Buchi Pump Module C-605 Instrukcja Użytkownika Pobierz pdf (Strona 19)

5 Putting into operation

19 Pump Combinations Operation Manual, Version E

Pressure tubing 1/8” x 1/16”:

Cut the pressure tubing to the desired length. Attach

the ﬁtting b and the ferrules to one end of the tubing

a as described.

Screw the ﬁtting b into the upper output e of

the separator head. Make sure that all ﬁttings are

hand-tight.

Fig. 5.3: Pump head with connected pressure tubing

5.3.2 Pump system 1: Pump Controller C-610 and 1 Pump Module C-601

NOTE

The Pump Controller C-610 can only be connected to the Pump Module C-601.

Place the pump module on a level surface. Make

sure the address bus is set to A b. If not, take the

screwdriver and turn the small white dot to A. Con-

nect the power cord a.

Fig. 5.4: Rear connections of the pump module

A holding angle is located in the center at the back

of the pump controller a. Remove it.

There is a rail located at the bottom of the pump

controller a. Slide it from the front to the end of the

stop b on the pump module c.

Attach the holding angle.

Fig. 5.5: Installing the pump controller and the pump module

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 49 50

Brak uwag

Buchi Pump Module C-605 Instrukcja Użytkownika Strona 19