Buchi Syncor Polyvap Instrukcja Użytkownika Pobierz pdf (Strona 15)

Syncore Platform

4.4 Function test for drive and speed indica-

tor

There should be no objects of any kind resting upon the

base plate or between the base-plate and the housing of

the equipment.

• Setaspeedof60RPMbyturningthespeedcontroller

 to the right.

• Thedisplayunit should indicate “60” and the base

plate of the basic unit should move slowly without any

pronounced vibration.

• Followingcompletionofthefunctiontest,resetthespeed

to 0 RPM

4.5 Function test heating and time

There should be no objects of any kind resting upon the

base plate or between the base-plate and the housing of

the equipment.

• Press once on the „UP“ button  on the temperature

con trol unit. The display  shifts from the current tempe-

ra ture to the set-point temperature.

• Pressthe„UP“buttonrepeatedlytosetanewset-point

for temperature of +40°C.

• After3seconds,theunittakesoverthisnewset-point.

• Pressthe„START“buttonrepeatedly.Thebaseplateis

heated to the set-point temperature. A dot in the tempe-

rature display  shows that the heater has been turned

ON.

• Thetimedisplay shows how much time has passed

since starting.

If not, contact a local BUCHI service agent.

• TurntheheaterOFFafterthefunctionaltestbypressing

once on the “STOP” button.

• Tocheckthetemperatureoftheheatingplate,insertan

external thermometer (Ø 4 mm) into the reference socket.

4 Putting into Operation

Figure 9: Controlling the basic functions from the control panel













1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 45 46

Brak uwag

Buchi Syncor Polyvap Instrukcja Użytkownika Strona 15