Buchi DuMaster D-480 Instrukcja Użytkownika Pobierz pdf (Strona 290)

Operation Manual D-480 ©BÜCH Labortechnik AG

10 - Menu and dialog descriptions 290

System > Auto run (Command)

What is the command used for?

This command starts continuous analysis, i.e. the system processes all samples in sample memory

up to the stop marker. Once the system reaches the stop marker, it either goes into idle mode or

sleep mode, depending on settings.

Short cuts

Invocation via the toolbar:

Note

You can only start the system if the following system conditions exist:

 System pressure is at least 800 mbar.

 Furnace temperatures are at most 50 °C below their setpoints.

 The system has detected that the base line is stable.

 Working temperature of the thermal conductivity detector is at least 59 °C.

If one of these conditions is not met, the system does not start and a message is displayed.

System > Single run (Command)

What is the command used for?

This command starts a single analysis, i.e. the next sample in sample memory (= current sample) is

processed. After processing the single sample, the system goes into idle mode again, regardless of

sleep settings.

Short cuts

Invocation via the toolbar:

Note

If you execute this command while continuous analysis is running, continuous analysis stops after

finishing the current sample and the system goes into idle mode.

You can only start the system if the following system conditions exist:

 System pressure is at least 800 mbar.

 Furnace temperatures are at most 50 °C below their setpoints.

 The system has detected that the base line is stable.

 Working temperature of the thermal conductivity detector is at least 59 °C.

If one of these conditions is not met, the system does not start and a message is displayed.

System > Stop (Command)

What is the command used for?

This command aborts a running analysis. The system goes into idle mode again, regardless of sleep

settings.

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 355 356

Brak uwag

Buchi DuMaster D-480 Instrukcja Użytkownika Strona 290